The D1 Pro Laser Module Fan Starts Working After Power-On

This article applies to:

D1 Pro with 5W, 10W, and 20W laser modules.

 

Issue Description

For the D1 Pro machine, the fan on the laser module should only work during framing or processing. If it works once the machine is powered on, please follow the instructions below to troubleshoot the issue.

 

Change the motherboard

Please refer to this video to change the motherboard.

• Replace the D1 Pro motherboard

 

If None of the Above Works

If you have followed the instructions above and the issue is still not resolved, please read the article in the link below, collect the troubleshooting steps you have taken, and contact xTool tech support for further advice.

• Help Tech Support Troubleshoot Faster