xTool-Customer-Service
Comments
Recent activity by xTool-Customer-Service
-
@Kaquila Yes, there are improvements for us to make about this. Thank you for your support and feedback!
- View comment
- 0 votes
-
@Mike Workman Yes, you are right about that. Thank you for answering.
- View comment
- 0 votes
-
@Thelma Wallace Sorry for the trouble, you may disconnect the power supply for the laser module to turn it off which is the only way at the moment.
- View comment
- 0 votes
-
@John Sarmiento Sorry for the late reply. It's actually normal since the laser module is separately powered from the machine. No need to worry about it. Nevertheless, we have improvements to make.
- View comment
- 0 votes
-
@Haunani Borges Sorry for the late reply. It's actually normal since the laser module is separately powered from the machine. No need to worry about it.
- View comment
- 0 votes
-
@Ferdinand Santos Yes, it is. The laser module is separately powered from the machine. Sorry for the late reply.
- View comment
- 0 votes
-
@Howard Atherton Hey Howard, the upload switch is on the motherboard.
- View comment
- -1 votes
-
@ Hey Charles, take a look at this one if it serves you: Installation and Troubleshooting of Limit Sensors
- View comment
- 0 votes
-
@Gary Franks Laserbox basic software was for D1 before we developed XCS, which is for D1, D1 Pro and M1 as we speak and maybe more of our products in the future. Since Laserbox basic software was n...
- View comment
- 0 votes
-
Hey Howard, You may look it up here on our Shopify store, https://www.xtool.com/collections/accessory?constraint=xtool-d1-d1-pro-series. Thank you!
- View comment
- 0 votes