User

Yvette

Member since
Total activity 63
Last activity
Following 0 users
Followed by 0 users
Votes 1
Subscriptions 51

Articles

Recent activity by Yvette

  • Use xTool Creative Space (XCS) on Your iPad

    xTool Creative Space (XCS) can run on iPad. Before you create works with XCS on your iPad, you need to connect you xTool device to XCS first. Preparations An iPad with the XCS app installed. If y...

    • 3 followers
    • 2 comments
    • 0 votes
  • Plug-In Functions & Benefits Explained

    In XCS v1.6, we introduced a plug-in feature that optimizes the entire laser processing workflow at maximum efficiency. Plug-in operates silently in the background without influencing your softwa...

    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • Large Errors in Auto-Measure

    Issue Description There are large errors in auto-measure results in XCS. Generally, the error value is less than 1mm when the thickness of basswood is 3mm in laser flag mode.   #1 Check the Materi...

    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • Clean the Protective Enclosure of xTool F1

    If the protective enclosure becomes dirty, you can clean it with a piece of soft cloth moistened with clean water.Note: Do not use chemical agents such as alcohol and borax to avoid damaging the pr...

    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • Use xTool P2 Honeycomb Panel

    Note: Handle the honeycomb panel with care. Dropping or crashing the honeycomb panel may deform it and affect its function as a working panel. Residues may remain in the honeycomb panel after ...

    • Updated
    • 1 follower
    • 0 comments
    • 1 vote
  • Troubleshoot the "U-axis driver exception" for xTool P2

    Issue Description This issue usually occurs when connecting xTool P2 with extension accessories, such as RA2 and the automatic conveyor feeder. If the machine is connected to XCS, you may see a po...

    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • Replace the Knob Module for xTool Smoke Purifier

    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • XCS Prompts “Sending File Failed”

    Issue Description When you click "Framing" or "Start" on XCS, the software will prompt the error message "Sending file failed. Please try again later"   #1 The Device Is Disconnected from XCS C...

    • Updated
    • 4 followers
    • 6 comments
    • -4 votes
  • Unboxing xTool Desktop Smoke Purifier

    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • The Laser Tube Won't Light Up

    Issue Description The laser tube won't light up when trying to process after turning on P2. A picture of a properly functioning laser tube is shown below. Attention: Do not touch the laser tube whe...

    • Updated
    • 1 follower
    • 0 comments
    • 0 votes