Rustin

Replace the Interface Board for xTool F1

• Rustin
• October 13, 2023 09:42
• 1 follower
• 0 comments
• 0 votes

Use xTool Creative Space (XCS) on Your iPad

xTool Creative Space (XCS) can run on iPad. Before you create works with XCS on your iPad, you need to connect you xTool device to XCS first. Preparations An iPad with the XCS app installed. If y...

• Rustin
• October 12, 2023 02:53
• 3 followers
• 2 comments
• 0 votes

Plug-In Functions & Benefits Explained

In XCS v1.6, we introduced a plug-in feature that optimizes the entire laser processing workflow at maximum efficiency. Plug-in operates silently in the background without influencing your softwa...

• Rustin
• Updated October 12, 2023 02:02
• 1 follower
• 0 comments
• 0 votes

Large Errors in Auto-Measure

Issue Description There are large errors in auto-measure results in XCS. Generally, the error value is less than 1mm when the thickness of basswood is 3mm in laser flag mode.   #1 Check the Materi...

• Rustin
• Updated October 09, 2023 09:39
• 1 follower
• 0 comments
• 0 votes

Clean the Protective Enclosure of xTool F1

If the protective enclosure becomes dirty, you can clean it with a piece of soft cloth moistened with clean water.Note: Do not use chemical agents such as alcohol and borax to avoid damaging the pr...

• Rustin
• Updated October 09, 2023 05:39
• 1 follower
• 0 comments
• 0 votes

Troubleshoot the "U-axis driver exception" for xTool P2

Issue Description This issue usually occurs when connecting xTool P2 with extension accessories, such as RA2 and the automatic conveyor feeder. If the machine is connected to XCS, you may see a po...

• Rustin
• Updated October 08, 2023 02:33
• 1 follower
• 0 comments
• 0 votes

Use xTool P2 Honeycomb Panel

Note: Handle the honeycomb panel with care. Dropping or crashing the honeycomb panel may deform it and affect its function as a working panel. Residues may remain in the honeycomb panel after ...

• Rustin
• Updated October 08, 2023 08:40
• 1 follower
• 0 comments
• 1 vote

Replace the Knob Module for xTool Smoke Purifier

• Rustin
• Updated September 25, 2023 06:00
• 1 follower
• 0 comments
• 0 votes

XCS Prompts “Sending File Failed”

Issue Description When you click "Framing" or "Start" on XCS, the software will prompt the error message "Sending file failed. Please try again later"   #1 The Device Is Disconnected from XCS C...

• Rustin
• Updated September 22, 2023 09:35
• 3 followers
• 5 comments
• -1 votes