[Video] Install the Air Assist Set for Different Lasers Support Updated November 23, 2022 09:20 6 comments Was this article helpful? Yes No 9 out of 13 found this helpful Have more questions? Comments 6 comments Sort by Date Votes Rick Horowitz December 03, 2022 16:02 Where is the information on M1? I didn't see that in the video. Admittedly, I kept fast-forwarding through what looked like D1 demonstrations, and I suppose it's theoretically possible I missed it, but I think I would have seen it. 1 Ed Coke December 22, 2022 18:20 I have the XTool enclosure. How do you route and secure the air line and what is the best location for the air assist unit. Saw the other video with a different enclosure but not the XTool one. Thx 1 Robert Morris February 14, 2023 16:31 No questions. The video and your email cleared up the omission of instructions. You may consider providing this omission to your Product Management group so that clear instructions can be packed in each new Air Assist set. It would save you and your customers a lot of grief. 1 xTool Customer Service February 16, 2023 07:27 Robert Morris Hello Robert, sorry for the trouble! This has been forwarded to our Product Team and should be dealt with accordingly! Thank you for the message and have a nice day! 0 Will Hayden March 07, 2023 05:27 Air assist for M1 is terrible design or explaination, or both! 1) you remove the dust cover which exposes the greased gear motor in the laser housing. No instructions are given to replace the dust cover or not. It makes sense to replace the dust cover as it holds the magnetic air assist in place better than not replacing it and it keeps the gear motor covered. HOWEVER, when you do so, the angle the air tube is routed, it routes on the opposite side of the engineering to hold the air tube. So if you leave the dust cover off and do as the instructions say, you expose the gears in the gear motor! AND, the air tube gets stuck in the back of the moving parts and jams with a horrible crunching sound when the laser returns to home I've watched numerous videos, read instructions a million times and this is a terrible make shift design flaw which is seemingly simple but confusing to the engineers who designed it. Not happy. 1 xTool Customer Service March 23, 2023 07:15 (Edited March 23, 2023 07:27) Hello Will Hayden Really appreciate your feedback. Sorry that our content hasn't lived up to your expectations. At xTool, we strive to create high-quality and accessible content for all xToolers, so they can solve the issue with their machines with ease. And with your suggestion, we are one step closer to that goal. We've noted down your suggestions for our team to review. Our support team will get back to you via email. Appreciate your support and suggestion. 0 Article is closed for comments.