Upgrade Firmware for M1 in XCS

Article author
xTool Support Team

Contents:

Upgrade firmware for M1 in XCS

1. Power on M1 and connect it to your computer.
2. Launch XCS.
3. Connect to M1 in XCS.
4. Click on the gear icon in the upper right corner of the XCS layout.
5. Click on Check for updates.1e6bb799-9961-4514-a88c-d682fc5d77c0.png
Notes:
  • Make sure your network is stable and in good condition.
  • Make sure your computer stays on, and do not enter Sleep mode during the process.
  • Do not power off M1 during the process.
  • It should be normal that M1 disconnects during the firmware update process when the latest firmware is being installed.

How to deal with upgrade failure?

  • Check the network connection or switch to another network and try again.
  • Check the device (M1) connection. Connection via the original USB cable is suggested.
  • Exit and relaunch XCS and try again.
  • Burn Firmware for M1 with a Micro SD Card.

Feel free to contact support@xtool.com via email if there is any problem.

Was this article helpful?

1 out of 3 found this helpful

Have more questions?

Comments

1 comment
  • I'm using Arial font and I want to adjust the the width of the text

    how can I update XCS in Beta 3, 4 or 5

    0

Article is closed for comments.