Replace the Laser Cooling Fan for F1

Article author
Vicky Team
  • Updated


This guide shows you how to replace F1's laser module cooling fan.


Things Needed

A hex key or hex screwdriver

(3/32″ or 2.5mm)


A replacement laser module cooling fan.




Prep the Machine

1. Start the machine, wait until it's fully powered on and the knob responding.

2. Turn the knob to raise the laser module until it moves to the maximum height.


3. Power off the machine, unplug the power cable, and take off the baseplate.

4. Lie down the machine with its front side facing up and put on the lens protector


Now the machine is in the right status and position for further operation.


Remove the Cover

1. Remove the four screws at the bottom of the laser module with the hex key.


2. Raise the machine, lower the shield, grasp the handle and pull the metal cover up.


3. Reverse the metal cover and find the logo indicator board. Unplug the cable.


Now the metal cover is completely severed from the machine.


Replace the Cooling Fan

1. Unscrew the fan using the hex key and unplug the connection cable.
2. Replace the fan with the new one, connect the cable, and install the screws.



Contact Us

We hope this guide is helpful. And we'd love to hear what you think.

If you have any questions, please contact us at:




Was this article helpful?

0 out of 0 found this helpful

Have more questions?



Please sign in to leave a comment.