How to Maintain M1

Guide Rail and Bearing Maintenance

The guide rails are chrome-plated shafts, and the bearings are made of bearing steel.

You need to apply grease or lubricant to them regularly to prevent rust and help the machine work properly.

• If you use M1 for more than 8 hours per day, apply grease to guide rails and bearings once every 15 days.
• If you use M1 for no more than 2 hours per day, apply grease to guide rails and bearings once every 2 months.
• Spray a small amount of WD40 on the guide rail or bearing to maintain it.

Note

• Before maintenance, clean the dirt and impurities from the surface of the drive shaft.
• During maintenance, spread evenly the grease, wipe off excess grease, and make sure the drive shaft is clean and free of impurities.
• After maintenance, manually move the laser module to ensure it is working properly.

Maintenance of Other Parts

• During processing, smoke and dust will be generated, and some may adhere to different parts of the device. Therefore, routine maintenance is required for the device.
• Power off the device, and use a dry cotton cloth to gently wipe the dirty parts. If a non-electronic part such as the camera or laser module lens is difficult to clean, wipe it with a cloth moistened with a little alcohol.