Use xTool P2 Material Clamps

Article author
Permanently deleted user

xTool P2 material clamps can work with materials with a maximum thickness of 12 mm.

You can use them as follows:

1. Place a board or sheet on the slats.

2. Stretch a clamp by holding the lower part with one hand and pulling the upper part up with the other hand, and then place the clamp around the material and a slat.

3. Fit the other three clamps in the same way.


Was this article helpful?

3 out of 3 found this helpful

Have more questions?



Please sign in to leave a comment.