The Lens Mount of the Air Assist Set Is Not the Ideal Angle

    Article author
    xTool Customer Service
    • Updated

    Issue Description

    The lens mount can not be tightened to the ideal angle as shown in the photo below.
    output (2).png

    Cause

    The screw thread is faulty.
    Note: If the lens mount is placed within the error range of plus or minus 30°, it will not affect the use of the machine.
    output (3).png

    Solution

    1. Tight the screw with the air nozzle, so less effort helps get a greater angle.
    2. Use a spare seal, put it under the other side of the lens, and install the mount.
    3. Wrap a loop of plumbing tape around the screw thread, and then install the mount.
    output (4).png

    Was this article helpful?

    1 out of 3 found this helpful

    Have more questions?

    Comments

    0 comments

    Article is closed for comments.