Auto-Measure Failed in Cylindrical Processing

Article author
xTool Customer Service
  • Updated

#1 Check the Red Light Spot

Make sure the red light spot is on the top of the material surface and try again.

#2: Check the Processing Material

Note: Errors usually occur in processing transparent or reflective material.
  1. Place a piece of white paper on the material and try again.
  2. Focus manually referring to the instructions below.

#3: Check the Processing Area

Adjust the material height within the limit of 16mm above the baseplate to 19mm below the baseplate.

Was this article helpful?

0 out of 0 found this helpful

Have more questions?

Comments

0 comments

Article is closed for comments.