The Tail Module Gets Stuck

    Article author
    xTool Customer Service
    • Updated
    This article applies to:
    D1 and D1 Pro
    Rotary Attachment
     

    Issue Description

    If the tail module gets stuck, please refer to this article for troubleshooting.
     

    #1 Check the Set Screw

    Unscrew it and screw it back in place.
    RA-tail-model.png
     

    #2 Check the Sliding Block

    1. Make sure the tail module is parallel to the rotary when you push it in.
    2. Check if there is any burr on the sliding blocks.
    3. Check if there is any obstacle in the dovetail groove.
    4. Try removing the burr or obstacle, or get a replacement

     

    If None of the Above Works

    If you have followed the instructions above and the issue is still not resolved, please read the article in the link below, collect the troubleshooting steps you have taken, and contact xTool tech support for further advice.

    Was this article helpful?

    0 out of 0 found this helpful

    Have more questions?

    Comments

    0 comments

    Article is closed for comments.