Mirrored Image in Cylindrical Processing

Article author
xTool Customer Service
  • Updated
This article applies to:
D1 and D1 Pro

Issue Description

If you use the rotary attachment, and the engraved image is flipped horizontally compared with the designed image, please refer to this article for troubleshooting.


#1 Check the Placement

Make sure the rotary is placed in the way shown in the below photo.


#2 Check the Lightburn Setting

If you are using Lightburn, enable the rotary attachment and the mirror output.

#3 Check the XCS Reflect Setting

Before processing, check the direction of the image. If it's flipped, check if the Reflect mode is enabled.

If None of the Above Works

If you have followed the instructions above and the issue is still not resolved, please read the article in the link below, collect the troubleshooting steps you have taken, and contact xTool tech support for further advice.



Was this article helpful?

1 out of 3 found this helpful

Have more questions?



Article is closed for comments.