Mirrored Image in Cylindrical Processing

    Article author
    xTool Customer Service
    • Updated
    This article applies to:
    D1 and D1 Pro
     

    Issue Description

    If you use the rotary attachment, and the engraved image is flipped horizontally compared with the designed image, please refer to this article for troubleshooting.

     

    #1 Check the Placement

    Make sure the rotary is placed in the way shown in the below photo.

    RA-placement.png
     

    #2 Check the Lightburn Setting

    If you are using Lightburn, enable the rotary attachment and the mirror output.
    RA-lightburn-enable.png
     

    #3 Check the XCS Reflect Setting

    Before processing, check the direction of the image. If it's flipped, check if the Reflect mode is enabled.
    RA-xcs-reflect.png
     

    If None of the Above Works

    If you have followed the instructions above and the issue is still not resolved, please read the article in the link below, collect the troubleshooting steps you have taken, and contact xTool tech support for further advice.

     

     

    Was this article helpful?

    1 out of 3 found this helpful

    Have more questions?

    Comments

    0 comments

    Article is closed for comments.