The D1 laser Module Fan Won't Work After Power-On

Article author
xTool Customer Service
  • Updated

This article applies to:

D1 with 5W/10W/20W laser modules.


Issue Description

For the D1 machine, the fan in the laser module should start working once the device is powered on. If not, please follow the instructions below to troubleshoot the issue.

#1 Check the Laser Cable

If the cable connecting the laser module and the motherboard is disconnected or loose, the module may not get enough power for the fan.

  1. Check if the indicator inside the module lights up.
  2. If not, could be a loose cable. Unplug and replug it in.
  3. If yes, please move on to the next step.

#2 Check the Fan Wire

  1. Take off the fan from the module and check for any damaged or loose wires according to this video.
  2. If there is a loose wire, replug it and make sure it's tight.
  3. If there is a damaged wire, the fan needs to be replaced.
  4.  If there is no loose or damaged wire, the fan itself could be faulty. It needs to be replaced.

Please refer to this video to change the fan.

If None of the Above Works

If you have followed the instructions above and the issue is still not resolved, please read the article in the link below, collect the troubleshooting steps you have taken, and contact xTool tech support for further advice.

Was this article helpful?

1 out of 1 found this helpful

Have more questions?



Article is closed for comments.